KK2.0 Test flight with GoPro Hero3

After playing around with a few boards This has got to be one of my favourits, as its quick to setup and use, full of features and very stable. I’ll recomend this board to anyone wanting to start building there own QuadCopters

KK2.15 Multi-rotor LCD Flight Controller in Protected Case Box

  • Generation KK2.15 board with updated sensors, memory, header pins and hard case protection
  • Package includes:
  • 1 x KK2.15 flight controller & protect case
  • 1 x Buzzer
  • If you’re new to multi-rotor flight or have been unsure about how to setup a KK board then the KK2 was built for you. The 6 Pin USBasp AVR programming interface ensures future software updates will be quick and easy.
  • Specifications:
  • Size: 50.5mm x 50.5mm x 12mm
  • Weight: 21 gram (Include Piezo buzzer)
  • IC: Atmega644 PA
  • Gyro/Acc: 6050MPU InvenSense Inc.
  • Auto-level: Yes
  • Input Voltage: 4.8-6.0V
  • AVR interface: standard 6 pin.
  • Signal from Receiver: 1520us (5 channels)
  • Signal to ESC: 1520us
  • Firmware Version: 1.9S.
  • Pre-installed firmware:
  • Dualcopter
  • Tricopter
  • Y6
  • Quadcopter +
  • Quadcopter X
  • Hexcopter +
  • Hexcopter X
  • Octocopter +
  • Octocopter X
  • X8 +
  • X8 X
  • H8
  • H6
  • V8
  • V6
  • Aero 1S Aileron
  • Aero 2S Aileron
  • Flying Wing
  • Singlecopter 2M 2S
  • Singlecopter 1M 4S
  • (Custom Mix via the “Mixer Editor” option)
  • The Mixer Editor allows you to adjust where and how much signal the motors receive from stick input and sensors. This allows you to create any configuration possible with up to 8 motors or servos.
Share

Leave a Reply

WordPress spam blocked by CleanTalk.